95" Black 5 Keg Beer Dispenser-Kegerator w/ 2 Dual Faucet- Beverage Air DD94HC-1-B

Beverage Air DD94HC-1-B 95" Draft Beer Dispenser - 5 Keg Kegerator with 2 Dual Faucet Tap Towers

The Beverage Air DD94HC-1-B is a 95" wide Kegerator with Two Dual Faucet Taps and room for five 1/2 barrel kegs. The wear resistant steel exterior sides and front resist smudges and finger prints. The top surface is stainless steel. Heavy duty construction by Beverage Air for high traffic commercial use.

Features of the Beverage Air DD94HC-1-B Keg Cooler

• 3-in-1 Draft Solution uses a single stainless-steel tap to serve different beverages, such as wine, beer, and coffee (or other non-alcoholic beverages) through silver-lined tubing that is 100% effective against the top 4 beverage spoiling bacteria
• Balanced refrigeration system maintains cold keg temperatures.
• 3" diameter insulated dispensing columns have cold air channeled through so beer will be maintained at proper temperature.
• Beverage Air Tap Coolers are equipped with self-closing doors with key locks. Magnetic gaskets create tight, positive door seal.
• Reinforced stainless steel floors and door sills won't buckle under weight of kegs.
• The Beverage Air DD94HC-1-B comes with a Sturdy stainless steel counter top with two stainless insulated towers and drip trays to make cleanup easy.
• Exterior: Black wear resistant steel front and sides, and galvanized back..
• Interior: Galvanized Steel walls and ceiling. Stainless Steel floor.
• Interior lamps.
• 120V, 1/3 HP. 8' cord. UL, NSF.
• Ships from IA, PA.
• Warranty: 3 Year Parts Labor, 7 Year Compressor

Need More Beer?

To dispense even more than the factory-default number of beers at one time, you will need a few other items as well:

• Extra CO2 hose (4 ft per each new keg is recommended) and 2 clamps for each new hose
• Beer line, hex nuts, and washers to attach your keg to the dispenser
• Additional coupler so you can hook up your CO2 line and beer line to the keg completes the setup.

To add an additional faucet to your existing draft arms:

• Depending on whether you want to add one offset, one inline, or two additional products, different kits are required. Each kit contains a sleeve, insulation, 3 set screws, and shank(s)
• For each product you are adding, a faucet will be needed
• The coupler, CO2 hose, clamps, etc. will be required here as well, as you are still adding additional kegs.