Glycol Beer Chiller Line Installation Kit

Beer, CO2, and Glycol Installation Kits from Rapids include all the items you need for final hook-up. This Glycol Kit includes the following: 1 roll of insulation tape, 2” wide x 30’ long 24' polyethylene sponge insulation for glycol trunk lines 1 roll of duct tape, 48mm wide x 55m long 25 feet of 3/8” ID high pressure braided beer tubing 2 worm drive hose clamps, fits 1/4"- 5/8” OD 4 worm drive hose clamps, fits 1/4” - 7/8” OD (up to 1/2" ID) 2 hose unions, stainless steel, for 3/8” x 3/8” ID tubing 1 beer faucet wrench Instructions: The braided tubing will connect the hose barbs on your glycol chiller unit to the designated glycol lines in the trunk line. Use the 4 larger hose clamps to attach the tubing to the chiller and to one end of the hose unions. The other end of the hose union should then be attached to the trunk line with the smaller hose clamps. After that, use the insulation and insulation tape to cover the braided tubing to keep the glycol cold. Use the duct tape to seal the seam on the insulation and keep everything in place.