Exterior top is one-piece, 22-gauge stainless steel with integral 2.12” (5.1cm) square nosing on the front. Top of unit has one opening to accept six 1/6-size 4” or 6” (10cm or 15cm) deep pans. Adapter bars and 1/6 size pans are supplied by Delfield. Lid is constructed of 20-gauge stainless steel. Temperature in top opening to maintain 33°F (1°C) to 41°F (5°C), with pans recessed 2.5” (6.4cm) at 86°F ambient room temperature, meeting NSF 7 requirements. One 27” x 10” x .5” (68.6cm x 25.4cm x 1.3cm) polyethylene cutting board treated with antimicrobial agent is mounted on the top at the front edge. Exterior back and bottom are two-piece 24-gauge galvanized steel. Exterior ends are stainless steel. Interior sides are thermoformed ABS plastic with integral shelf supports. Base is fully insulated with high-density foamed in place environmentally friendly, Kyoto Protocol Compliant, Non ODP (Ozone Depletion Potential), Non GWP (Global Warming Potential) polyurethane. Refrigeration system uses HFC-404A refrigerant. Compressor is 1/5 H.P., with condenser coil and hot gas condensate evaporator mounted on rear of the cabinet. Evaporator coils are located on the interior rear wall of the cabinet. Refrigerant flow is controlled by a capillary tube. Cabinet maintains an interior cabinet temperature of 36°F to 40°F (2°C to 4°C). ACT control: ACT electronic, solid state control, mounted on
the exterior rear of the cabinet, allows unit to maintain precise temperatures in heavy duty conditions. Electrical connection is 115 volt, 60 Hertz, single phase. Unit has a 7’ (2.1m) long electrical cord and NEMA 5-15P plug. Casters: Equipment is mounted on 5” (13cm) diameter plate casters with front two locking. Equipment clearance above the floor is 2.5” (6cm). Doors have a 24-gauge stainless steel exterior, with thermoformed ABS plastic interior liner. Cabinet has one adjustable epoxy-coated wire shelf.