Installation Parts for Beer Tower Drip Trays w/Rinsers

These are the parts required to attach a water source to a pressure regulated rinser on a drip tray. The pressure regulator will make sure that not too much water pressure is going to the rinser, preventing malfunction and inadvertent launching your glassware into the ceiling and/or causing personal injury from too much vertical thrust. Installing this kit will simplify cleaning an repair of your glass rinser allowing you to show down the water supply and disconnect only the rinser without requiring you to shut down water to your entire bar area. You will need one shutoff valve and regulator for each rinser along with up to 6 hose clamps and the length of water line to get you from your water source to the rinser. Typical installations look like this: Hose clamp to attach water line to water source -> water line -> shutoff valve -> hose clamp to small run of water line -> small run of water line -> hose clamp to pressure regulator -> pressure regulator -> hose clamp to water line -> water line -> hose clamp to hose adapter for drip tray -> attach hose adapter to rinser on drip tray.